一二三四在线观看免费视频-成人免费无码大片a毛片软件-国产又色又爽又黄刺激视频-久久久久88色偷偷

• Knowledge of pressure regulation during plastic injection molding

  In injection molding, whether with hydraulic or electric machines, all motions generate pressure. Proper pressure control is crucial for quality products.Pressure Regulation and Measurement SystemHydr

  2025/01/22 Pressure Regulation in Plastic Injection Molding

• Injection molding is not complete how to do?

  Adjusting the production process is crucial for enhancing product quality and output. Given the short injection - molding cycle, poor process control will yield numerous defective products. When makin

  2025/01/20 Injection molding problems

• What is the closed-loop system of injection molding machine?

  The injection molding control system is a cyclic process that contains a set of preset programs. The next cycle will run only when certain conditions are met. The inspection and monitoring of these co

  2025/01/18 closed-loop system

• Plastic gear injection molding process and material analysis

  Development Trends of Plastic GearsPlastic gears are advancing towards larger sizes, more complex geometries, and higher strength. High - performance resins and long glass fiber - filled composites dr

  2025/01/15 Plastic gear injection molding

• Comparison of shrinkage rate of common plastics

  The shrinkage rate of plastics refers to the percentage by which the size of a plastic product shrinks relative to the size of the mold cavity after it is taken out from the mold and cooled to room te

  2025/01/10 Shrinkage rate of plastic

• Plastic raw material quality index glossary

  1. Density and Relative DensityDensity: Mass per unit volume of a substance, calculated as mass - to - volume ratio. Units are Mg/m3, kg/m3, or g/cm3.Relative Density: Ratio of a substance's densi

  2025/01/08 Plastic raw material

• 30 common problems and countermeasures in injection molding process

  1. When the product is just started, the cause and solution of the product lack of glue after a period of productionWhen the injection molding machine material tube melts due to long heating time, low

  2025/01/06 hooren

• The segmented principle of multistage injection molding

  I. Flow Characteristics of Plastic MeltScrew - Propelling PhaseInitial Segment:Usually starts from the beginning of injection molding. Its main function is to enable the plastic melt to stably enter t

  2025/01/06 Multistage injection molding