-
![How to choose screws for different raw materials]()
How to choose screws for different raw materials
In plastics and related industries, screw selection for different raw materials is crucial. Here are some guidelines:1. Thermoplastic Raw MaterialsPolyethylene (PE)Features: Good fluidity, low viscosi
2024/11/11 Screws for different raw materials
-
![What are the details of the fiber reinforced PC plastic injection molding process?]()
What are the details of the fiber reinforced PC plastic injection molding process?
Polycarbonate (PC) is a high - performance engineering plastic. When reinforced with fibers (e.g., glass fiber), its mechanical properties are enhanced, finding wide use in electronics, automotive, an
2024/11/08 PC plastic injection molding
-
![Die surface treatment technology]()
Die surface treatment technology
Die surface treatment technologies enhance die performance and quality. Here are some common ones:1. NitridingPrinciple: The die is placed in a nitrogen - containing medium at 500 - 600 °C. For hot wo
2024/11/06 Die surface treatment
-
![ABS resin injection molding processing points]()
ABS resin injection molding processing points
ABS resin injection molding requires attention to several key processing points:1. Material DryingImportance: ABS resin is hygroscopic. Moisture can cause bubbles in products during injection molding,
2024/11/04 ABS
-
![The reason and the solution of injection molding material shortage]()
The reason and the solution of injection molding material shortage
Injection molding lack of material is a common issue. Here are the causes and corresponding solutions:1. Injection Molding Process ParametersUnderinjection pressureCause: Hydraulic component failures
2024/11/01 Injection molding material shortage
-
![What is a test spline injection mold]()
What is a test spline injection mold
Test Spline Injection MoldA test spline injection mold is crucial for material evaluation. Here's a concise introduction:1. Material RequirementsStrength & Hardness: High - strength and hard m
2024/10/28 Test spline injection mold
-
![Difference between PA11 and PA12]()
Difference between PA11 and PA12
PA11 and PA12 are both types of nylon, also known as polyamide 11 and polyamide 12.They are both thermoplastic polymers, but their raw material sources, physical properties and prices are different.Fi
2024/10/23 PA11 and PA12
-
![How much does the wall thickness of plastic parts affect the product?]()
How much does the wall thickness of plastic parts affect the product?
The wall thickness of plastic parts has a significant influence on product quality.First, mechanical propertiesStep 1: IntensityAdequate wall thickness provides sufficient strength. If the wall thickn
2024/10/21 The wall thickness of plastic parts
